| |
SWR SM-900 Bass Amp
$1,799.99
 |
|
-
FRONT PANEL:
-
All tube preamp gain stages
-
Dual independent input jacks compatible for both active and passive instruments
-
Gain control with LED peak clipping indicator
-
Limiter with variable threshold control
-
Exclusive Aural Enhancer circuitry
-
Master volume control w/clip LED indicator
-
Active bass and treble controls
-
2 independent switchable
-
3-band semi-parametric EQs
-
EQ footswitch
-
Effects blend control
-
Tuner send
-
Electronic crossover
-
Rackmountable
-
Bi Amp Crossover Point Control: 100Hz to 1000Hz
-
Crossover Slope: 12 dB per octave
-
Rack Handles
-
REAR PANEL:
-
Stereo and Mono Effects Loop
-
Balanced XLR Output with select switch for Line or Direct Mode
-
Ground lift & pad control
-
High and Low Crossover Outputs
-
Power Amp Assign Switch selects Bridge or Stereo Mode
-
SPEAKER OUTPUTS:
-
2 - 1/4" jacks each for Left and Right Stereo Out
-
One Speakon jack for Left and Right Side Output
-
One Speakon Output Jack for Mono Operation
-
Speaker fuses (x2): 3AG, 10 Amp, Fast Blo
-
Line Fuse: 3AG, 8 Amp, Slow Blo
-
On/Off Switch
-
INTERNAL:
-
(1) 12AX7 Preamp Tube
-
Cooling fan
-
FREQUENCY RESPONSE: (Power amplifier): -3dB @ 20Hz and 40KHz
-
SENSITIVITY:
-
Full output, 8 ohm load, 100Hz
-
Passive Input Jack: 50 millivolts
-
Active Input Jack: 200 millivolts
-
Power Amplifiers (Effects Return Jack "in"):1.6 volts
-
DiISTORTION:
-
Power Amplifiers (Effects Return Jack "in"): 0.03% THD
-
I.M. This page is for information, comments, and public reviews about the SWR SM-900 Bass Amp. Distortion: 0.06%
-
System Distortion
-
(Gain and Master Volume full, Enhancer at minimum
-
and Tone controls set flat): 0.4% THD
-
SIGNAL TO NOISE RATIO: -75dB (
|
|
|
