Traynor DynaBass 800H Bass Amp Head
$799.00

 

Traynor DynaBass 800H Bass Amp Head , Bass

Reviews

  • 800W at 4 ohms
  • Hybrid tube/solid state preamp design (switchable)
  • 5-band EQ with sweep mid with additional Scoop & Bass Resonance controls
  • Footswitchable Tube Overdrive with Clean Blend
  • Onboard Compression and Limiting
  • Tuner mute
  • Active and passive instrument level inputs
  • Integrated metal flip handles
  • XLR balanced Pre/Post DI output
  • Integrated solid plywood sleeve w/additional single 19" accessory rack space
  • Amp In (rear)
  • Parametric mid
  • Wet/Dry Blend on EFX Return
  • Wet/Dry control on Drive mode
  • Tuner mute switch and 1/4" tuner out jack
  • Bass resonance
  • Master volume control
  • Effects Loop (Rear)
  • 12 LED output power display with Clip indicator
  • Dual fan cooling system

Traynor DynaBass 800H Bass Amp Head
The Traynor DynaBass 800H is set apart from other bass amp heads by its versatile hybrid tube and solid state preamp. Read user reviews for Traynor DynaBass 800H Bass Amp Head. The all-tube input signal path gives you as much grunge or as little tube warmth as you want. Meanwhile, the FET-driven solid state input circuit ensures highly responsive and clean tone. The DynaBass amp head`s innovative blend control ensures the right mix of raw power and definition.

Built for the most demanding stages, the DynaBass 800H is one of the highest-powered bass amps Traynor`s ever offered. The highly efficient solid state amplifier section reliably delivers 800W to a 4-ohm load for maximum compatibility with a typical live rig.

A dual fan cooling system integrated into the DynaBass 800H completely negates the need for heavier heatsinks. Well placed intake/exhaust vents allow the two cooling fans to immediately draw all extraneous heat away from the amplifier to make sure the amplifier won`t overheat even under the most extreme live conditions.

Innovative tone-shaping controls like Scoop and Bass Resonance are standard on the DynaBass 800H as well as a compressor with user-definable threshold and a customizable output limiter. The variable contour Scoop function sweeps from a flat frequency response through a mid-frequency dip at 400Hz. As you increase beyond the halfway point on the control, you begin to boost both the top and bottom end to your tone, in addition to further reducing the midrange level. The Bass Resonance control actually controls the damping factor of the amplifier`s output stage, and lets you take full advantage of the tone of a loudspeaker enclosure. When used with a high quality and responsive loudspeaker like the Traynor TC810, Bass Resonance allows you to dial in the exact response from your rig that you want to hear - anything from a tight and punchy modern tone to a looser, more vintage bass sound. The five-band EQ with semi-parametric mid also aids in finding the tones you need.

Other professional features added to the DynaBass 800H include highly visible VU metering of the output signal, a front panel wet/dry control for the footswitchable tube drive, footswitchable effects return with front panel wet/dry blend control, and a pre/post selectable XLR balanced DI output with ground lift. High power handling Speakon extension speaker cabinet outputs have been added in addition to the 1/4-inch phono jacks commonly used on instrument amplifiers.

Order today with the no-risk assurance of our Total Satisfaction and Low Price Guarantees!

  • Power at min. impedance: 600W at 8 ohms; 800W at 4 ohms; 600W at 2 ohms
  • Minimum impedance (ohms): 2
  • Burst power - 2 cycle: 1000
  • Channel 1 - inputs: 2x1/4
  • Channel 1 - controls: 5-band EQ with parametric sweepable mid, Tube Gain
  • Channel 1 - switches: Limiter, Compressor, Tube Drive, Tuner Mute
  • Input sensitivity (mV): 80
  • Master outputs: Speakon, 1/4" (x2)
  • Line out: (type/configuration): XLR (Pre/Post switchable)
  • Line out sensitivity (Vrms): 1.0
  • Effects Footswitch/Function: Tube Drive/Effects Loop
  • Effects Return sensitivity (Vrms): 1.0
  • LED Indicators: Power, Tube Drive, Compressor, Mute, EFX Rtn
  • Protection: Thermal, Short Circuit
  • Limiter/Switchable: Yes/Yes (Output Clip Limiter)
  • Dimensions: 21"W x 8.5"H x 16"D
  • Weight: 47 lb.

Home > Bass > Hybrid Amp Heads

What's New and Hot

Markbass Studio Pre 500 Bass Amp Head
$1,499.99

Markbass TSA 500 Bass Amp Head
$1,199.99

Markbass F 500 Bass Amp Head
$799.99

Ampeg SVT-6PRO 1100 Watt Tube/Solid State Bass Head
$899.99 - $1,299.99

 

2009 © MUZtronic is not responsible for typographical errors in pricing or product
specification inaccuracies in our catalogs or online shop. Prices are subject to change without notice.